Agilent Technologies 35670A Manual page 388

MMEMory
MMEMory:LOAD:LIMit:UPPer:TRACe[1|2|3|4]
Loads an upper limit for the specified trace from a file on the specified disk.
Command Syntax:
<FILENAME> ::= '[<PATH>]<filename>'
<PATH> ::= <MSIS>[{DOS_DIR}]
<MSIS> ::= RAM:|NVRAM:|INT:|
<DOS_DIR> ::= \<DIR_NAME>\
<DIR_NAME> ::= ASCII characters
<filename> ::= ASCII characters (see beginning of chapter for
Example Statements:
Attribute Summary:
Description:
This command loads the contents of a file into the upper limit register of the specified trace. The file
must have been saved either with the MMEM:STOR:LIM:UPP, MMEM:STOR:LIM:LOW, or
MMEM:STOR:TRAC command.
The trace specifier selects the trace—TRAC1 for trace A, TRAC2 for trace B, TRAC3 for trace C, or
TRAC4 for trace D. Trace A is the default if you do not specify a trace. The parameter specifies the
source.
Additional limit commands are available under CALCulate:LIMit and
DISPlay[:WINDow[1|2|3|4]]:LIMit.
15-14
MMEMory:LOAD:LIMit:UPPer:TRACe[1|2|3|4] <FILENAME>
EXT[,<select_code>[,<unit _number>]]:
(DOS only)
<filename> restrictions)
OUTPUT 711;"Mmemory:Load:Limit:Upp:Trace2 'TRACE1'"
OUTPUT 711;"MMEM:LOAD:LIM:UPP:TRACE 'INT:MYTRACE'"
Option: not applicable
Synchronization Required:
Preset State: not applicable
SCPI Compliance:
no
instrument-specific
command