Access-List - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

access-list

Syntax
Release Information
Description
Options
Mode
78
Standard IP access list:
access-list accessListName { permit | deny }
{ srcIP srcWildIp | [ host ] srcIPHost | any } [ log ]
no access-list accessListName [ { permit | deny }
{ srcIP srcWildIp | [ host ] srcIPHost | any } [ log ] ]
Extended IP access list:
access-list accessListName { permit | deny } ip { srcIP srcWildIp |
host srcIPHost | any } { dstIP dstWildIp | host dstIPHost | any } [ log ]
no access-list accessListName [ { permit | deny } ip { srcIP srcWildIp |
host srcIPHost | any } { dstIP dstWildIp | host dstIPHost | any } [ log ] ]
Command introduced before JunosE Release 7.1.0.
Defines a standard or extended IP access list. The extended access list enables you to
specify a destination address or host, precedence, and type of service. This command
imposes an implicit last rule of " deny ip any any" to deny all routes that do not match
previous rules in the access list. The no version removes the IP access list, the specified
entry in an access list, or the log for a specified entry.
accessListName—String of up to 32 alphanumeric characters
permit—Permits access if the conditions are matched
deny—Denies access if the conditions are matched
srcIP—Source IP address from which the packet is being sent
srcWildIp—Wildcard mask IP address
host—Identifies the address as a host
srcIPHost—Source host IP address; assumes a wildcard mask of 0
any—Creates an address of 0.0.0.0 with a wildcard mask of 255.255.255.255
dstIP—Destination IP address
dstWildIp—Wildcard mask IP address for destination
dstIPHost—Destination host IP address to which the packet is being sent
log—Logs an Info event into the ipAccessList log whenever the access-list rule is
matched
Global Configuration
Copyright © 2010, Juniper Networks, Inc.