Enable Ipsec-Transport - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
enable ipsec-transport
Syntax
Release Information
Description
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] enable ipsec-transport
Command introduced before JunosE Release 7.1.0.
IP Tunnel Destination Profile Configuration mode added in JunosE Release 8.2.0.
In IP Tunnel Destination Profile Configuration mode, specifies that the router accepts
only dynamic IP tunnels protected by an IPSec transport connection. The no version
disables IPSec transport mode.
In L2TP Destination Profile Host Configuration mode, specifies that the router accepts
only L2TP tunnels protected by an IPSec transport connection. The no version disables
IPSec transport mode.
IP Tunnel Destination Profile Configuration, L2TP Destination Profile Host Configuration
Chapter 6: E Commands
555
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?