Enable Ipsec-Transport - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

Chapter 6: E Commands

enable ipsec-transport

[ no ] enable ipsec-transport
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
IP Tunnel Destination Profile Configuration mode added in JUNOSe Release 8.2.0.
In IP Tunnel Destination Profile Configuration mode, specifies that the router accepts
Description
only dynamic IP tunnels protected by an IPSec transport connection. The no version
disables IPSec transport mode.
In L2TP Destination Profile Host Configuration mode, specifies that the router accepts
only L2TP tunnels protected by an IPSec transport connection. The no version disables
IPSec transport mode.
IP Tunnel Destination Profile Configuration, L2TP Destination Profile Host
Mode
Configuration
557
enable ipsec-transport