Adapter Accept - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

adapter accept

Syntax
Release Information
Description
Options
Mode
80
adapter accept adapterSpecifier
Command introduced in JunosE Release 7.1.0.
Erases from NVS the type and configuration of the previous I/O adapter (IOA) in the
specified IOA bay, and allows you to configure a new IOA. Issue this command after you
have installed a different type of IOA in an IOA bay. You can use this command only when
the state of the IOA is not present or disabled (mismatch). There is no no version.
NOTE: Issuing this command reboots the line module associated with the
IOA, but it does not accept its configuration.
To accept the configuration of the line module and its associated IOAs, issue
the slot accept command.
adapterSpecifier—Particular IOA in the format slot/adapter:
slot—Number of the chassis slot; for E120 routers, in the range 0–5; for E320 routers,
in the range 0–5 or 11–16
adapter—Identifier for the IOA within the chassis slot, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router) or the upper
IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or the lower
IOA bay (E320 router).
Global Configuration
Copyright © 2010, Juniper Networks, Inc.