Mirroring-Group Monitor-Port - 3Com S7906E Command Reference Manual

Examples
# Configure port Ethernet 2/0/1 as the outbound mirroring port of remote port mirroring group 1 in
system view.
<Sysname> system-view
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 monitor-egress Ethernet 2/0/1
# Configure port Ethernet 2/0/2 as the outbound mirroring port of remote port mirroring group 2 in
Ethernet port view.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-source
[Sysname] interface Ethernet 2/0/2
[Sysname-Ethernet2/0/2] mirroring-group 2 monitor-egress

mirroring-group monitor-port

Syntax
mirroring-group group-id monitor-port monitor-port-id
undo mirroring-group group-id monitor-port monitor-port-id
View
System view
Default Level
2: System level
Parameters
group-id: Port mirroring group number, in the range of 1 to 4.
monitor-port-id: Port index. You need to provide this argument in the form of interface-type
interface-number, where interface-type is the port type and interface-number is the port number.
Description
Use the mirroring-group monitor-port command to configure the destination port for a port mirroring
group.
Use the undo mirroring-group monitor-port command to remove the destination port from a port
mirroring group.
Note that:
A port mirroring group can contain only one destination port.
The destination port cannot be a member port of the current mirroring group.
The destination mirroring port can be an access, trunk, or hybrid port. It must be assigned to the
remote mirroring VLAN.
A remote source port mirroring group cannot contain destination ports.
Before configuring the destination port for a port mirroring group, make sure the port mirroring
group exists.
Do not enable STP, RSTP, or MSTP on the destination port. Otherwise, the mirroring function may
be affected.
1-5