Display Rrpp Verbose - 3Com S7906E Command Reference Manual

Field
Link-Down
Common Flush FDB
Complete Flush FDB
Edge Hello
Major Fault
Packet Total

display rrpp verbose

Syntax
display rrpp verbose domain domain-id [ ring ring-id ]
View
Any view
Default Level
1: Monitor level
Parameters
domain-id: RRPP domain ID, in the range 1 to 8.
ring-id: RRPP ring ID, in the range 1 to 64.
Description
Use the display rrpp verbose command to display detailed information about RRPP configuraiton.
If you have specified an RRPP ring ID in the command, the detailed information of the specified ring in
the specified RRPP domain appears. Otherwise, the detailed information of all the rings in the specified
RRPP domain appears.
Examples
# Display the detailed information of ring 1 in RRPP domain 1.
<Sysname> display rrpp verbose domain 1 ring 1
Domain ID
Control VLAN
Protected VLAN: Reference Instance 0 to 2, 4
Hello Timer
Ring ID
Ring Level
Node Mode
Ring State
Enable Status : Yes
Primary port
Link-Down packet statistics received/sent on the port
Common-Flush-FDB packet statistics received/sent on the port
Complete-Flush-FDB packet statistics received/sent on the port
Edge-Hello packet statistics received/sent on the port
Major-Fault packet statistics received/sent on the port
Total number of packets received/sent on the port. Here only Hello,
Link-Down, Common-Flush-FDB, Complete-Flush-FDB, Edge-Hello,
and Major-Fault packets of RRPP are counted.
: 1
: Major 5 Sub 6
: 1 sec Fail Timer : 3
: 1
: 1
: Master
: Complete
Active Status: Yes
: GigabitEthernet3/0/1
Description
sec
Port status: UP
1-7