Protected-Vlan - 3Com S7906E Command Reference Manual

You can configure ring groups only on edge nodes or assistant-edge nodes.
A subring can be assigned to only one ring group.
A device must be of the same type, an edge node or an assistant-edge node, in the subrings in a
ring group.
To assign an activated ring to a ring group, first assign the ring to the assistant-edge node ring
group and then to the edge node ring group.
To remove an activated ring from a ring group, first remove the ring from the edge node ring group
and then from the assistant-edge node ring group.
The subrings in a ring group must have the same link in the primary ring. Otherwise, the ring group
cannot function properly.
An edge node ring group and its corresponding assistant-edge node ring group must be the same
in configurations and activation status.
Related commands: rrpp ring-group, display rrpp ring-group.
Examples
# Configure subrings for ring group 1.
<Sysname> system-view
[Sysname] rrpp ring-group 1
[Sysname-rrpp-ring-group1] domain 1 ring 1 to 3 5
[Sysname-rrpp-ring-group1] domain 2 ring 1 to 3 5

protected-vlan

Syntax
protected-vlan reference-instance instance-id-list
undo protected-vlan [ reference-instance instance-id-list ]
View
RRPP domain view
Default Level
2: System level
Parameters
reference-instance instance-id-list: Specifies the MSTIs to be referenced. The range of the
instance-id-list argument is as specified in the command configuring MSTIs.
Description
Use the protected-vlan command to configure the protected VLANs for the RRPP domain. The
protected VLANs are specified by the MSTIs. You can use the display stp region-configuration
command to check the VLANs corresponding to the specified MSTIs.
Use the undo protected-vlan command to remove the protected VLANs of the RRPP domain. If no
MSTI is specified, all protected VLANs of the RRPP domain are removed.
By default, no protected VLAN is specified for an RRPP domain.
Note that:
1-10