Mirroring-Group Monitor-Egress - 3Com S7906E Command Reference Manual

Examples
# Add ports to port mirroring group 1 as source ports (assuming that port mirroring group 1 already
exists).
<Sysname> system-view
[Sysname] mirroring-group 1 mirroring-port Ethernet 2/0/1 to Ethernet 2/0/5 both
# Remove source mirroring ports from port mirroring group 1.
[Sysname] undo mirroring-group 1 mirroring-port Ethernet 2/0/1 to Ethernet 2/0/3 both

mirroring-group monitor-egress

Syntax
In system view:
mirroring-group group-id monitor-egress monitor-egress-port-id
undo mirroring-group group-id monitor-egress monitor-egress-port-id
In Ethernet port view:
mirroring-group group-id monitor-egress
undo mirroring-group group-id monitor-egress
View
System view, Ethernet port view
Default Level
2: System level
Parameters
group-id: Port mirroring group number, in the range of 1 to 4.
monitor-egress-port-id: Index of the port to be configured as the outbound mirroring port. You need to
provide this argument in the format of { interface-type interface-number }, where interface-type is port
type and interface-number is port number.
Description
Use the mirroring-group monitor-egress command to configure a port as the outbound mirroring port
of a remote port mirroring group.
Use the undo mirroring-group monitor-egress command to remove the outbound mirroring port
configured from a remote port mirroring group.
Note that:
Only remote source port mirroring groups can have outbound mirroring ports. A port mirroring
group can have only one outbound mirroring port.
The outbound port cannot be a member port of the current mirroring group.
It is not recommended to configure STP, RSTP, MSTP, 802.1X, IGMP Snooping, static ARP and
MAC address learning on the outbound mirroring port; otherwise, the mirroring function may be
affected.
1-4