3Com S7906E Command Reference Manual page 458

Secondary port: GigabitEthernet3/0/2
# Display the detailed information of all the rings in RRPP domain 2.
<Sysname> display rrpp verbose domain 2
Domain ID : 2
Control VLAN : Major 10
Protected VLAN: Reference Instance 3, 5 to 7
Hello Timer : 1 sec
Ring ID : 1
Ring Level : 0
Node Mode : Master
Ring State : Complete
Enable Status : Yes
Primary port : GigabitEthernet3/0/4
Secondary port: GigabitEthernet3/0/5
Ring ID : 2
Ring Level : 1
Node Mode : Edge
Ring State : -
Enable Status : No
Common port : GigabitEthernet3/0/4
GigabitEthernet3/0/5
Edge port : GigabitEthernet3/0/3
Table 1-4 display rrpp verbose command output description
Field
Domain ID
Control VLAN
Protected VLAN
Hello Timer
Fail Timer
Ring ID
Ring Level
Node Mode
Ring State
Enable Status
Port status: BLOCKED
Sub 11
Fail Timer : 3 sec
Active Status: Yes
Port status: UP
Port status: BLOCKED
Active Status: No
Port status: -
Port status: -
Port status: -
RRPP domain ID
Control VLANs of the RRPP domain, including major control VLAN and sub
control VLAN
List of VLANs protected by the RRPP domain. MSTIs are displayed here.
To get the VLANs corresponding to these MSTIs, use the display stp
region-configuration command.
Hello Timer value configured in seconds
Fail Timer value configured in seconds
RRPP ring ID
RRPP ring level, with 0 representing primary ring and 1 representing
subring
Node mode: master node, transit node, edge node and assistant edge node
RRPP ring state. This field makes sense only when the node mode field is
master node. "Complete" appears when the ring is in health state; "Failed"
appears when the ring is in disconnect sate; and "–" appears in all the other
cases.
RRPP ring enable status: Yes indicates enabled and No indicates disabled
1-8
Description