3Com S7906E Command Reference Manual page 455

If you have specified an RRPP ring ID in the command, RRPP message statistics of the specified
RRPP ring in the specified RRPP domain on the current device appears. Otherwise, RRPP
message statistics of all RRPP rings in the specified RRPP domain appears.
If some port belongs to more than one ring, its packets are taken statistics based on the rings. You
will view the statistics of the port under the current ring.
When a ring transits from inactive status into active status, its packets will be counted again..
Related commands: reset rrpp statistics.
Examples
# Display RRPP message statistics of ring 1 in RRPP domain 1.
<Sysname> display rrpp statistics domain 1 ring 1
Ring ID : 1
Ring Level : 1
Node Mode : Master
Active Status : Yes
Primary port : GigabitEthernet3/0/1
Packet
Direct Hello
------------------------------------------------------------------------
Send 16424
Rcv 0
Secondary port: GigabitEthernet3/0/2
Packet
Direct Hello
------------------------------------------------------------------------
Send 0
Rcv 16378
# Display RRPP message statistics of RRPP domain 2.
<Sysname> display rrpp statistics domain 2
Ring ID : 1
Ring Level : 0
Node Mode : Master
Active Status : Yes
Primary port : GigabitEthernet3/0/3
Packet
Direct Hello
------------------------------------------------------------------------
Send 16924
Rcv 0
Secondary port: GigabitEthernet3/0/4
Packet
Direct Hello
------------------------------------------------------------------------
Send 0
Rcv 16878
Ring ID : 2
Link Common
Down Flush FDB
0 0
0 0
Link Common
Down Flush FDB
0 0
0 0
Link Common
Down Flush FDB
0 0
0 0
Link Common
Down Flush FDB
0 0
0 0
Complete Edge Major Packet
Flush FDB Hello Fault Total
1 0 0
0 0 0
Complete Edge Major Packet
Flush FDB Hello Fault Total
0 0 0
1 0 0
Complete Edge Major Packet
Flush FDB Hello Fault Total
1 0 0
0 0 0
Complete Edge Major Packet
Flush FDB Hello Fault Total
0 0 0
1 0 0
1-5
16425
0
0
16379
16925
0
0
16879