Display Rrpp Ring-Group - 3Com S7906E Command Reference Manual

Table 1-1 display rrpp brief command output description
Field
Flags for Node Mode
RRPP Protocol Status
Number of RRPP Domains
Domain ID
Control VLAN
Protected VLAN
Hello Timer
Fail Timer
Ring ID
Ring Level
Node Mode
Primary/Common Port
Secondary/Edge Port
Enable Status

display rrpp ring-group

Syntax
display rrpp ring-group [ ring-group-id ]
View
Any view
Default Level
1: Monitor Level
Parameters
ring-group-id: Ring group ID, in the range 1 to 8.
RRPP node mode: M represents master node, T represents transit
node, E represents edge node and A represents assistant edge node
RRPP protocol status: Enable (globally enabled)/Disable (globally
disabled)
Number of RRPP domains configured
RRPP domain ID
Control VLANs of an RRPP domain: Major and Sub
List of VLANs protected by the RRPP domain. MSTIs are displayed
here. To get the VLANs corresponding to these MSTIs, use the
display stp region-configuration command.
Hello Timer value configured in seconds
Fail Timer value configured in seconds
RRPP ring ID
RRPP ring level, with 0 representing primary ring and 1 representing
subring
Node mode
Primary port when the node mode is master node or transit node;
common port when the node mode is edge node or assistant edge
node; "-" appears when the port is not configured on the ring or the
board to which the port belongs does not start.
Secondary port when the node mode is master node or transit node;
edge port when the node mode is edge node or assistant edge node;
"-" appears when the port is not configured on the ring or the board to
which the port belongs does not start.
RRPP ring status: Yes indicates enabled and No indicates disabled.
1-3
Description