Arp Static - 3Com S7906E Command Reference Manual

Parameters
number: Maximum number of dynamic ARP entries that an interface can learn, in the range 1 to 8192.
Description
Use the arp max-learning-num command to configure the maximum number of dynamic ARP entries
that a VLAN interface can learn.
Use the undo arp max-learning-num command to restore the default.
Examples
# Specify VLAN-interface 40 to learn up to 500 dynamic ARP entries.
<Sysname> system-view
[Sysname] interface vlan-interface 40
[Sysname-Vlan-interface40] arp max-learning-num 500

arp static

Syntax
arp static ip-address mac-address [ vlan-id interface-type interface-number ] [ vpn-instance
vpn-instance-name ]
undo arp ip-address [ vpn-instance-name ]
View
System view
Default Level
2: System level
Parameters
ip-address: IP address in an ARP entry.
mac-address: MAC address in an ARP entry, in the format H-H-H.
vlan-id: ID of a VLAN to which a static ARP entry belongs to, in the range 1 to 4094.
interface-type interface-number: Interface type and interface number.
vpn-instance vpn-instance-name: Name of a VPN instance, a case-sensitive string of 1 to 31
characters.
Description
Use the arp static command to configure a static ARP entry in the ARP mapping table.
Use the undo arp command to remove an ARP entry.
Note that:
A static ARP entry is effective when the device works normally. However, when the VLAN or VLAN
interface to which an ARP entry corresponds is deleted, the entry, if permanent, will be deleted,
and if non-permanent and resolved, will become unresolved.
The vlan-id argument is used to specify the corresponding VLAN of an ARP entry and must be the
ID of an existing VLAN. In addition, the Ethernet interface following the argument must belong to
that VLAN. The VLAN interface of the VLAN must have been created.
1-2