Rrpp Ring-Group - 3Com S7906E Command Reference Manual

Default Level
2: System level
Parameters
None
Description
Use the rrpp enable command to enable RRPP protocol.
Use the undo rrpp enable command to disable RRPP protocol.
By default, RRPP protocol is disabled.
To activate the RRPP domain, RRPP protocol and the RRPP ring must be enabled simultaneously.
Related commands: ring enable.
Examples
# Enable RRPP protocol.
<Sysname> system-view
[Sysname] rrpp enable

rrpp ring-group

Syntax
rrpp ring-group ring-group-id
undo rrpp ring-group ring-group-id
View
System view
Default Level
2: System level
Parameters
ring-group-id: Ring group ID, in the range 1 to 8.
Description
Use the rrpp ring-group command to create an RRPP ring group and enter ring group view.
Use the undo rrpp ring-group command to delete an RRPP ring group. After removing a ring group, all
subrings in the ring group do not belong to any ring group.
Note that:
The subrings assigned to the same ring group must have the same edge node. Similarly, they must
have the same assistant-edge node. Additionally, these subrings must have the same link in the
primary ring.
As an edge node ring group and an assistant-edge node group are configured on different devices.
If the two groups are configured with different subrings, the ring group function fails.
To remove a ring group, remove the edge node ring group, and then the corresponding
assistant-edge node ring group.
1-16