Ring Enable - 3Com S7906E Command Reference Manual

[Sysname-rrpp-domain1]
secondary-port gigabitethernet 3/0/2 level 1
# Specify the device as the edge node of primary ring 20 in RRPP domain 1, and GigabitEthernet 3/0/1
as the edge port.
<Sysname> system-view
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] control-vlan 100
[Sysname-rrpp-domain1] protect-vlan reference-instance 0 1 2
[Sysname-rrpp-domain1] ring 20 node-mode edge edge-port gigabitethernet 3/0/1
# Specify the device as the assistant edge node of primary ring 20 in RRPP domain 1, and
GigabitEthernet 3/0/1 as the edge port.
<Sysname> system-view
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] control-vlan 100
[Sysname-rrpp-domain1] protect-vlan reference-instance 0 1 2
[Sysname-rrpp-domain1] ring 20 node-mode assistant-edge edge-port gigabitethernet 3/0/1

ring enable

Syntax
ring ring-id enable
undo ring ring-id enable
View
RRPP domain view
Default Level
2: System level
Parameters
ring-id: RRPP ring ID, in the range 1 to 64.
Description
Use the ring enable command to enable the RRPP ring.
Use the undo ring enable command to disable the RRPP ring.
By default, the RRPP ring is disabled.
Note that:
To enable subrings, you must first enable the primary ring before enabling subrings.
You must first disable all the subrings in the RRPP domain and then disable the primary ring.
To activate the RRPP domain, RRPP protocol and the RRPP ring must be enabled simultaneously.
Related commands: rrpp enable.
Examples
# Enable RRPP ring 10 in RRPP domain 1.
<Sysname> system-view
ring 20 node-mode
1-14
transit primary-port gigabitethernet 3/0/1