Interrupts And Errors; Initialization And Configuration; Module Initialization; Configuring A Memory-To-Memory Transfer - Texas Instruments Concerto F28M36 Series Technical Reference Manual

www.ti.com

16.3.10 Interrupts and Errors

When a µDMA transfer is complete, the µDMA controller generates a completion interrupt on the interrupt
vector of the peripheral. Therefore, if µDMA is used to transfer data for a peripheral and interrupts are
used, then the interrupt handler for that peripheral must be designed to handle the µDMA transfer
completion interrupt. If on any channel the transfer is initiated by software, then the completion interrupt
occurs on the dedicated software µDMA interrupt vector (see
When µDMA is enabled for a peripheral, the µDMA controller stops the normal transfer interrupts for a
peripheral from reaching the interrupt controller (the interrupts are still reported in the peripheral's interrupt
registers). Thus, when a large amount of data is transferred using µDMA, instead of receiving multiple
interrupts from the peripheral as data flows, the interrupt controller receives only one interrupt when the
transfer is complete. Unmasked peripheral error interrupts continue to be sent to the interrupt controller.
If the µDMA controller encounters a bus or memory protection error as it attempts to perform a data
transfer, it disables the µDMA channel that caused the error and generates an interrupt on the µDMA error
interrupt vector. The processor can read the DMA Bus Error Clear (DMAERRCLR) register to determine if
an error is pending. The ERRCLR bit is set if an error occurred. The error can be cleared by writing a 1 to
the ERRCLR bit.
Table 16-6 shows the dedicated interrupt assignments for the µDMA controller.
Note: Software should always do a RMW (read modify write) to the DMASWREQ (0x400F_F014) register,
because if any channel (which is enabled for SW transfer) bit in this register gets cleared by SW before
dma transfer completion, then transfer completion interrupt wont be generated, even though the dma
transfer completes successfully.

16.4 Initialization and Configuration

16.4.1 Module Initialization

Before the µDMA controller can be used, it must be enabled in the System Control block and in the
peripheral. The location of the channel control structure must also be programmed.
The following steps should be performed one time during system initialization:
1. Enable the µDMA peripheral in the System Control block. To do this, set the UDMA bit of the Run
Mode Clock Gating Control Register 2 (RCGC2) register.
2. Enable the µDMA controller by setting the MASTEREN bit of the DMA Configuration (DMACFG)
register.
3. Program the location of the channel control table by writing the base address of the table to the DMA
Channel Control Base Pointer (DMACTLBASE) register. The base address must be aligned on a 1024-
byte boundary.

16.4.2 Configuring a Memory-to-Memory Transfer

µDMA channel 30 is dedicated for software-initiated transfers. However, any channel can be used for
software-initiated, memory-to-memory transfer if the associated peripheral is not being used.
16.4.2.1 Configure the Channel Attributes
Follow these steps to configure the channel attributes:
1. Program bit 30 of the DMA Channel Priority Set (DMAPRIOSET) or DMA Channel Priority Clear
(DMAPRIOCLR) registers to set the channel to High priority or Default priority.
2. Set bit 30 of the DMA Channel Primary Alternate Clear (DMAALTCLR) register to select the primary
SPRUHE8E – October 2012 – Revised November 2019
Submit Documentation Feedback
Table 16-6. µDMA Interrupt Assignments
Interrupt
46
47
Copyright © 2012–2019, Texas Instruments Incorporated
Functional Description
Table 16-6).
Assignment
µDMA Software Transfer
µDMA Error
M3 Micro Direct Memory Access ( µDMA)
1201