Usb Host Receive Polling Interval Endpoint N Register (Usbrxinterval[N]); Usbrxinterval[N] Frame Numbers; Usb Host Receive Polling Interval Endpoint N Register(Usbrxinterval[N]) Field Descriptions - Texas Instruments Concerto F28M36 Series Technical Reference Manual

www.ti.com
18.5.43 USB Host Receive Polling Interval Endpoint n Register
(USBRXINTERVAL[1]USBRXINTERVAL[15])
The USB host receive polling interval endpoint n 8-bit registers (USBRXINTERVAL[n]), for interrupt and
isochronous transfers, define the polling interval for the currently selected transmit endpoint. For bulk
endpoints, this register defines the number of frames after which the endpoint should time out on receiving
a stream of NAK responses.
The USBRXINTERVAL[n] registers values define a number of frames, as follows:
Transfer Type
Interrupt
Isochronous
Bulk
For the specific offset for each register see
Mode(s): OTG A or Host
The USBRXINTERVAL[n] registers are shown in
Figure 18-54. USB Host Receive Polling Interval Endpoint n Register (USBRXINTERVAL[n])
7
LEGEND: R/W = Read/Write; -n = value after reset
Table 18-59. USB Host Receive Polling Interval Endpoint n Register(USBRXINTERVAL[n])
Bit Field Value
7-0 TXPOLL / 0
NAKLMT
SPRUHE8E – October 2012 – Revised November 2019
Submit Documentation Feedback
Table 18-58. USBRXINTERVAL[n] Frame Numbers
Speed
Low-speed or Full-speed
Full-speed
Full-speed
TXPOLL / NAKLMT
Description
TX Polling / NAK Limit The polling interval for interrupt/isochronous transfers; the NAK limit for bulk
transfers. See Table 18-58
Copyright © 2012–2019, Texas Instruments Incorporated
Valid Values (m) Interpretation
0x01-0xFF The polling interval is m frames.
0x01-0x10 The polling interval is 2
The NAK Limit is 2
0x02-0x10
disables the NAK timeout function.
Table 18-4.
Figure 18-51 and described in
R/W-0
Field Descriptions
for valid entries; other values are reserved.
M3 Universal Serial Bus (USB) Controller
Register Descriptions
(m-1)
frames.
(m-1)
frames. A value of 0 or 1
Table 18-54.
0
1391