Usb Receive Hub Address Endpoint N Registers (Usbrxhubaddr[1]- Usbrxhubaddr[15]); Usb Receive Hub Address Endpoint N Registers (Usbrxhubaddr[N]); Usb Receive Hub Address Endpoint N Registers(Usbrxhubaddr[N]) Field Descriptions - Texas Instruments Concerto F28M36 Series Technical Reference Manual

Table of Contents

Advertisement

Register Descriptions
18.5.26 USB Receive Hub Address Endpoint n Registers (USBRXHUBADDR[1]-
USBRXHUBADDR[15])
The receive hub address endpoint n 8-bit read/write registers (USBRXHUBADDR[n]), like [n], must be
written only when a full- or low-speed Device is connected to receive endpoint EPn via a USB 2.0 hub.
Each register records the address of the USB 2.0 hub through which the target associated with the
endpoint is accessed.
Note: USBTXHUBADDR0 is used for both receive and transmit for endpoint 0.
For the specific offset for each register see
Mode(s):
OTG A or Host
The USBRXHUBADDR[n] registers are shown in
Figure 18-31. USB Receive Hub Address Endpoint n Registers (USBRXHUBADDR[n])
7
6
MULTTRAN
R/w-0
LEGEND: R/W = Read/Write; -n = value after reset
Table 18-34. USB Receive Hub Address Endpoint n Registers(USBRXHUBADDR[n])
Bit
Field
Value
7
MULTTRAN
0
1
6-0
ADDR
0
1368
M3 Universal Serial Bus (USB) Controller
Table
Field Descriptions
Description
Multiple Translators
Clear to indicate that the hub has a single transaction translator.
Set to indicate that the hub has multiple transaction translators.
Device Address specifies the USB bus address for the target Device.
Copyright © 2012–2019, Texas Instruments Incorporated
18-4.
Figure 18-31
and described in
ADDR
R/W-0
SPRUHE8E – October 2012 – Revised November 2019
www.ti.com
Table
18-34.
0
Submit Documentation Feedback

Advertisement

Table of Contents
loading

Table of Contents