Honda Accord 2008 Manual page 1793

07/11/02 09:38:21 61TA0000_200_0226
Seats
Rear Seat Removal/Installation (cont'd)
Seat Cushion
NOTE:
• Take care not to scratch the body or tear the seat
covers.
• 4-door is shown; 2-door is similar.
1. Remove the bolt between the seat-back (A) and the
seat cushion (B).
＊０６
Fastener Location
: Bolt, 1
2. Pull each front edge of the seat cushion (A) up to
release the hooks (B), then pull back the seat
cushion, and remove it.
＊０７
B
3. Install the seat cushion in the reverse order of
removal, and note these items:
• Before attaching the seat cushion, make sure
there are no twists or kinks in the seat belts.
• When installing the seat cushion, slip the seat
belt buckles through the slits in the seat cushion.
20-224
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
A
B
A
Seat Side Bolster - 4-door
SRS components are located in this area. Review the
SRS component locations (see page 24-19) and the
precautions and procedures (see page 24-23) before
doing repairs or service.
NOTE: Take care not to scratch the body or tear the seat
covers.
1. Remove the seat cushion.
2. Remove the bolt securing the seat side bolster (A).
Fastener Location
: Bolt, 1
A
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
＊０８