Honda Accord 2008 Manual page 1794

07/11/02 09:38:21 61TA0000_200_0227
3. Fold the seat-back forward.
4. Lift the seat side bolster side bolster (A) up to
release the hooks (B), then remove the seat side
bolster.
＊０９
5. Install the seat side bolster in the reverse order of
removal, and note these items:
• Guide the belts over the front of the seat side
bolster as you install the bolster.
• Before attaching the seat side bolster, make sure
there are no twists or kinks in the seat belts.
B
A
B
Rear Seat-back Latch Replacement
NOTE:
• Take care not to bend or scratch the interior trim.
• 4-door is shown; 2-door is similar.
1. Remove the rear shelf (see page 20-119).
2. Disconnect the seat-back release cable (A) from the
seat-back latch (B), and remove the bolts, then
remove the latch. Take care not to damage the
cable fastener (C).
Fastener Locations
: Bolt, 2
A
B
3. Install the latch in the reverse order of removal, and
note these items:
• Make sure the release cable is connected
securely.
• Make sure the seat-back locks securely and
unlocks properly.
ＴＡ０８Ａ００Ｊ４６１６６４５３９７１ＫＢＡＴ００
C
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
20-225 20-225
＊０１