Honda Accord 2008 Manual page 1786

07/11/02 09:37:52 61TA0000_200_0219
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
4-door
SRS components are located in this area. Review the
SRS component locations (see page 24-19) and the
precautions and procedures (see page 24-23) before
doing repairs or service.
• Check the operation of the driver's seat position
sensor after any of these actions (see page 24-42):
– Driver's seat position sensor replacement
– Cover plate (front side of driver's seat slide rail)
replacement
• Calibrate the ODS unit after any of the these actions
(see page 24-40):
– Front passenger's seat replacement (including any
seat components)
– Replacement of the seat weight sensors
– After a vehicle collision
NOTE:
• Put on gloves to protect your hands.
• Take care not to tear the seams of damage the seat
covers.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Remove the front seat (see page 20-180).
2. 10-way power seat: Remove the screw, and release
the hooks (A), tabs (B), and pin (C), then remove the
front cover (D).
＊０１
Fastener Location
: Screw, 1
C
D
A
3. 10-way power seat: Remove the recline cover (A).
–1 Remove the screw, and detach the clip.
–2 Detach the tabs (B).
–3 Pull up the cover, then release the hook (C) and
the tab (D).
–4 Remove the upper recline inner cover (E).
–5 Disconnect the power seat adjustment switch
connector (F) and the lumbar support switch
connector (G).
–6 Remove the wire harness (H) from the hooks (I).
Fastener Locations
: Screw, 1
H
F
4. Manual height adjustable seat: Pull back the cap (A)
to release the hooks (B), and remove the screws,
then remove the height adjuster handle (C).
Fastener Locations
: Screw, 2
B
B
B
ＴＡ０８ＡＱＥＪ４６１２７０５３６３３ＫＢＡＴ１０
: Clip, 1
E
G
B
C
A
I
B
A
C
20-217
＊０２
D
B
B
＊０３
B
(cont'd)