Honda Accord 2008 Manual page 1777

07/11/02 09:37:46 61TA0000_200_0210
Seats
Front Seat-back Cover Replacement
(cont'd)
16. Install the cover in the reverse order of removal,
and note these items:
• Reinitialize the ODS unit (see page 24-39).
• To prevent wrinkles when installing a seat-back
cover, make sure the material is stretched evenly
over the pad before securing the clips, the hooks,
and the hook strips.
• Before installing the seat-back cover, make sure
airbag wires (A, B, C) are installed to the
reinforcing cloths (D) correctly, and wire A and
wire C are securely assembled.
• Replace any clips you removed with new ones (E).
• Reinstall airbag wire A, B and the bracket (F) of
airbag wire C securely.
• Use only original Honda replacement seat-back
covers.
• Make sure the seat-back heater harness (if
equipped), and OPDS sensor harness
(passenger's seat) are routed properly.
• Replace the back cover clips with new ones.
＊１４
D
＊１５
20-208 20-208
B
A
C
F
E
Front Seat Cushion Cover
Replacement
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
2-door
SRS components are located in this area. Review the
SRS component locations (see page 24-21) and the
precautions and procedures (see page 24-23) before
doing repairs or service.
• Check the operation of the driver's seat position
sensor after any of these actions (see page 24-42):
– Driver's seat position sensor replacement
– Cover plate (front side of driver's seat slide rail)
replacement
• Calibrate the ODS unit after any of the these actions
(see page 24-40):
– Front passenger's seat replacement (including any
seat components)
– Replacement of the seat weight sensors
– After a vehicle collision
NOTE:
• Put on gloves to protect your hands.
• Take care not to tear the seams of damage the seat
A
covers.
• Use the appropriate tool from the KTC trim tool set to
B avoid damage when removing components.
1. Remove the front seat (see page 20-180).
B
A
ＴＡ０８ＡＢＡＪ４６１２７０５３６３３ＫＢＡＴ１０