Honda Accord 2008 Manual page 1772

07/11/02 09:37:43 61TA0000_200_0205
18. Pull back the edge of the seat-back cover all the
way around, and release the upholstery rings (A),
then remove the seat-back cover.
NOTE: The leather seat cover is shown; the other
types of seat covers are similar.
＊１８
B
19. Remove airbag wire B from the outside reinforcing
cloths (D). Pull airbag wire A out through loops (E)
of the inside reinforcing cloths (F) and through a
loop (G) of airbag wire C, then remove the wires.
＊１９
D
B
D
F
C
20. Install the cover in the reverse order of removal,
and note these items:
• Reinitialize the ODS unit (see page 24-39).
• To prevent wrinkles when installing a seat-back
cover, make sure the material is stretched evenly
over the pad before securing the upholstery rings,
A
the hooks, and the hook strips.
• Before installing the seat-back cover, make sure
airbag wires (A, B, C) are installed to the
reinforcing cloths (D) correctly, and wire A and
wire C are securely assembled.
• Replace any upholstery rings you removed with
new ones (E). Install them with commercially
available upholstery ring pliers (F).
• Reinstall airbag wire A , B, and the bracket (G) of
airbag wire C securely.
• Use only original Honda replacement seat-back
covers.
• Make sure the side airbag harness and the seat
wire harness are routed properly.
D
F
A
D
E
G
A
B
B
G
C
E
F
20-203
＊２０
A
B
A
＊２１