Honda Accord 2008 Manual page 1795

07/11/02 09:38:22 61TA0000_200_0228
Seats
Rear Seat-back Release Lever/Cable Removal/Installation
NOTE:
• Take care not to bend or scratch the interior trim.
• 4-door is shown; 2-door is similar.
1. Remove the rear shelf (see page 20-119).
2. Disconnect the seat-back release cable (A) from the
seat-back latch (B), and detach the cable clip (C)
(2-door) or the cable clip (D) (4-door). Take care not
to damage the cable fastener (E).
＊０１
Fastener Locations
C
B
3. Open the trunk lid.
20-226
: Clip, 1 D : Clip, 1
(2-door)
(4-door)
A
E
C or D
4. From the trunk compartment, push the tab (A) to
release the hook (B), and slide the seat-back release
lever (C) inward to release the hook (D), then
remove it by pulling it out.
D
C
5. Install the release lever/cable in the reverse order
of removal, and note these items:
• Make sure the release cable is connected
securely.
• Make sure the seat-back locks securely and
unlocks properly.
A
ＴＡ０８Ａ００Ｊ４６１６６４５４０２９ＫＤＡＴ００
B
A
＊０２