Front Drive Shaft Installation - Honda MUV700 big red Service Manual

FRONT DRIVING MECHANISM
NOle
rne
,nSlaJ/81l{)n
Install the shaft boot band and a new outboard boot
d.recrlOn of the
band onto the outboard boot. SHAFT BOOT BAND
TABS
band (page
19-9/ Bend down each band end and secure it with the
lock tabs. Tap the lock tabs with a plastic hammer.
The left drive shaft
IS
longer lhan rhe
fIght dfive shaft.
Do
not mrerdlange
them
Be
care ful nat /0
damage thB 01/ seal
/fl
the gear case
Install the shaft boot band and a new inboard boot
band onto the inboard boot.
Bend down each band end and secure it with the
lock tabs. Tap the lock tabs with a plastic hammer.
INSTALLATION
Install a new stopper ring into the groove in the
inboard joint splines.
Install the drive shaft by holding the inboard joint
until the stopper ring seats in the groove of the
differential.
Make sure that the stopper ring is seated properly
by pulling on the inboard joint lightly.
InSlalllhe knuckle !page 15-14).
OUTBOARD BAND
111
OUTBOARD BOOT BAND
f3Il!
.....
SHAFT BOOT BAND INBOAFIO JOINT
STOPPER RING
II
19-11