Ip Igmp Promiscuous - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
ip igmp promiscuous
Syntax
Release Information
Description
Options
Mode
820
ip igmp promiscuous { on | off }
no ip igmp promiscuous
Command introduced before JunosE Release 7.1.0.
Enables the specified interface to accept IGMP reports from hosts on any subnet. The
no version specifies that an IGMP interface should use the Router Configuration mode
setting (see the igmp promiscuous command) to determine from which subnets it can
accept IGMP reports.
on—Enables the interface to accept IGMP reports from hosts on any subnet
off—Allows the interface to accept IGMP reports only from hosts on subnets associated
with this interface
Interface Configuration, Profile Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers