ST STM32F301 6 Series Reference Manual page 539

RM0366
Bit 7 BIF: Break interrupt flag
Bit 6 TIF: Trigger interrupt flag
Bit 5 COMIF: COM interrupt flag
Bits 4:3 Reserved, must be kept at reset value.
Bit 2 CC2IF: Capture/Compare 2 interrupt flag
Bit 1 CC1IF: Capture/Compare 1 interrupt flag
Bit 0 UIF: Update interrupt flag
This flag is set by hardware as soon as the break input goes active. It can be cleared by
software if the break input is not active.
0: No break event occurred
1: An active level has been detected on the break input
This flag is set by hardware on the TRG trigger event (active edge detected on TRGI input
when the slave mode controller is enabled in all modes but gated mode, both edges in case
gated mode is selected). It is set when the counter starts or stops when gated mode is
selected. It is cleared by software.
0: No trigger event occurred
1: Trigger interrupt pending
This flag is set by hardware on a COM event (once the capture/compare control bits –CCxE,
CCxNE, OCxM– have been updated). It is cleared by software.
0: No COM event occurred
1: COM interrupt pending
refer to CC1IF description
This flag is set by hardware. It is cleared by software (input capture or output compare
mode) or by reading the TIMx_CCR1 register (input capture mode only).
0: No compare match / No input capture occurred
1: A compare match or an input capture occurred
If channel CC1 is configured as output: this flag is set when the content of the counter
TIMx_CNT matches the content of the TIMx_CCR1 register. When the content of
TIMx_CCR1 is greater than the content of TIMx_ARR, the CC1IF bit goes high on the
counter overflow (in up-counting and up/down-counting modes) or underflow (in down-
counting mode). There are 3 possible options for flag setting in center-aligned mode, refer
to the CMS bits in the TIMx_CR1 register for the full description.
If channel CC1 is configured as input: this bit is set when counter value has been
captured in TIMx_CCR1 register (an edge has been detected on IC1, as per the edge
sensitivity defined with the CC1P and CC1NP bits setting, in TIMx_CCER).
This bit is set by hardware on an update event. It is cleared by software.
0: No update occurred.
1: Update interrupt pending. This bit is set by hardware when the registers are updated:
– At overflow regarding the repetition counter value (update if repetition counter = 0) and if
the UDIS=0 in the TIMx_CR1 register.
– When CNT is reinitialized by software using the UG bit in TIMx_EGR register, if URS=0
and UDIS=0 in the TIMx_CR1 register.
– When CNT is reinitialized by a trigger event (refer to
control register (TIM15_SMCR)), if URS=0 and UDIS=0 in the TIMx_CR1 register.
General-purpose timers (TIM15/TIM16/TIM17)
RM0366 Rev 5
Section 19.5.3: TIM15 slave mode
539/874
574