Adding A Static Route - 3Com 3CRWX120695A, 3CRWX440095A Configuration Manual

82 C 4: C
HAPTER ONFIGURING AND
0.0.0.0/ 0 Static
0.0.0.0/ 0 Static
10.0.2.1/24 IP
10.0.2.1/32 IP
10.0.2.255/32 IP
224.0.0.0/ 4 IP

Adding a Static Route

M IP I
ANAGING NTERFACES AND
1 Router
2 Router
0 Direct
0 Direct
0 Direct
0 Local
(For more information about the fields in the output, see the
LAN Switch and Controller Command
To add a static route, use the following command:
set ip route {default | ip-addr mask | ip-addr/mask-length}
gateway metric
The metric (cost) can be any number between 0 and 2,147,483,647.
Lower-cost routes are preferred over higher-cost routes. When you add
multiple routes to the same destination, MSS groups the routes together
and orders them from lowest cost at the top of the group to highest cost
at the bottom of the group. If you add a new route that has the same
destination and cost as a route already in the table, MSS places the new
route at the top of the group of routes with the same cost.
To add a default route that uses gateway 10.5.4.1 and has a cost of 1,
type the following command:
WX1200# set ip route default 10.5.4.1 1
success: change accepted.
To add two default routes and configure MSS to always use the route
through 10.2.4.69 when the WX interface to that gateway router is up,
type the following commands:
WX1200# set ip route default 10.2.4.69 1
success: change accepted.
WX1200# set ip route default 10.2.4.17 2
success: change accepted.
To add an explicit route from a WX switch to any host on the 192.168.4.x
subnet through the local router 10.5.4.2, and give the route a cost of 1,
type the following command:
WX1200# set ip route 192.168.4.0 255.255.255.0 10.5.4.2 1
success: change accepted.
S
ERVICES
10.0.1.17 Down
10.0.2.17 vlan:2:ip
vlan:2:ip
vlan:2:ip:10.0.1.1/24
vlan:2:ip:10.0.1.1/24
MULTICAST
Reference.)
Wireless