Display Route-Policy - 3Com Switch 4500 Family Manual

Examples
# Display the information about the address prefix list named p1.
<Sysname> display ip ip-prefix p1
name
p1
Table 4-1 Description on the fields of the display ip ip-prefix command
name
index
conditions
ip-prefix / mask
GE
LE

display route-policy

Syntax
display route-policy [ route-policy-name ]
View
Any view
Parameters
route-policy-name: Name of a routing policy, a string of up to 19 characters.
Description
Use the display route-policy command to display information about routing policies.
If you do not specify a route policy name, this command displays all route-policies configured.
Related commands: route-policy.
Examples
# Display information about routing policy named policy1.
<Sysname> display route-policy policy1
Route-policy : policy1
Permit 10 : if-match (ip-prefix) p1
index conditions
10 permit
Field
apply cost 100
ip-prefix / mask
10.1.0.0/16
Name of an IP-prefix
Internal sequence number of an IP-prefix
Matching mode, including
permit
deny
IP prefix/mask length for matching IP prefixes
Greater-equal, that is, lower limit of subnet mask
length of the matched IP address
Less-equal, that is upper limit of subnet mask
length of the matched IP address
4-3
GE LE
17 18
Description