®
R&S
ZNB/ZNBT
Step 2: Connectors and Cal Kits
Selects the connector type and gender for all ports and allows you to import a calibra-
tion kit.
Background information
Refer to
Messages in the dialog
An information message (or error message) is displayed, if one of the following hap-
pens:
●
One of the selected calibration kits is described by ideal kit parameters or typical
values.
●
One of the selected calibration kits does not contain all standards that are required
for the previously selected calibration type.
●
Different connector types are defined at the ports but the selected calibration type
requires uniform connectors.
●
A cal kit standard does not cover the entire calibrated frequency range.
●
The selected power meter does not cover the entire calibrated frequency range.
Figure 5-37: SMARTerCal(Manual), Step 2: Connectors and Cal Kits
The layout of the main panel depends on the number of test ports available.
User Manual 1173.9163.02 ─ 62
Chapter 4.5.2, "Calibration standards and calibration
GUI reference
Cal softtool
kits",
on page 174.
500