Calculate<Chn>:Eye:mask Auto - R&S ZNB Series User Manual

®
R&S ZNB/ZNBT
CALCulate<Chn>:EYE:JITTer:TYPE:RANDom <Boolean>
Enables/disables random jitter insertion in the generator simulation of the related eye
diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
The standard deviation can be set using
STDDeviation.
Note that jitter will not be applied unless the jitter functionality is activated using
CALCulate<Chn>:EYE:JITTer:STATe.
Suffix:
<Chn>
Parameters:
<Boolean>
Options:
Manual operation:
CALCulate<Chn>:EYE:JITTer:TYPE:USER <Boolean>
Enables/disables user-defined jitter insertion in the generator simulation of the related
eye diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Prior to enabling user-defined jitter, the jitter values must have been loaded from file
using MMEMory:LOAD:EYE:JITTer.
Note that jitter will not be applied unless the jitter functionality is activated using
CALCulate<Chn>:EYE:JITTer:STATe.
Suffix:
<Chn>
Parameters:
<Boolean>
Options:
Manual operation:
CALCulate<Chn>:EYE:MASK AUTO
Automatically creates an eye mask, based on the current eye measurement settings.
Suffix:
<Chn>
Usage:
User Manual 1173.9163.02 ─ 62
CALCulate<Chn>:EYE:JITTer:RANDom:
.
Channel number used to identify the active trace
*RST: OFF
R&S ZNB/ZNBT-K20
See "Random" on page 699
.
Channel number used to identify the active trace
*RST: OFF
R&S ZNB/ZNBT-K20
See "User Specific" on page 700
.
Channel number used to identify the active trace
Setting only
Command reference
SCPI command reference
870