R&S ZNB Series User Manual page 721

®
R&S ZNB/ZNBT
Channel Settings
The "Channel Settings" page allows you to change the measurement channel configu-
ration proposed by the "DUT Centric Wizard" based on the properties of the DUT, the
RF topology and the selected measurements.
Depending on the
must be set up:
●
one channel for S-parameter measurements
●
one channel for intermodulation measurements
Summary
The "Summary" page of the "DUT Centric Wizard"
●
summarizes which channels will be created and which parameters they will mea-
sure
●
allows you where to define these channels (new setup, append to current setup,
replace current setup)
●
allows you to decide whether to proceed with a (suitable) calibration
User Manual 1173.9163.02 ─ 62
"Measurement Selection" on page 715, either one or two channels
GUI reference
Applic softtool
721