R&S ZNB Series User Manual page 889

®
R&S ZNB/ZNBT
CALCulate:FMODel:DEASsistant:COUPon:LEFT:PORT <Position>, <PortNum>
CALCulate:FMODel:DEASsistant:COUPon:RIGHt:PORT <Position>, <PortNum>
Defines the port or ports for measuring the selected test coupon
FMODel:DEASsistant:COUPon:RIGHt:TYPE)
Parameters:
<Position>
Setting parameters:
<PortNum>
Options:
Manual operation:
CALCulate:FMODel:DEASsistant:COUPon:LEFT:TYPE <CouponType>
CALCulate:FMODel:DEASsistant:COUPon:RIGHt:TYPE <CouponType>
For fixture modeling with the deembedding assistant, this command selects a test cou-
pon to be measured for the lead-in/lead-out, or loaded from file.
The valid test coupons depend on the selected deembedding tool
FMODel:DEASsistant:TOOL).
ISD
SFD
EZD
●
To measure the test coupon, use:
–
–
●
To load the measurement data from file, use
ant:COUPon:<LEFT|RIGHt>:FILE.
Parameters:
<CouponType>
User Manual 1173.9163.02 ─ 62
UPLeft | UPRight
UPLeft
Left side of the test coupon
UPRight
Right side of the test coupon (SYMMetric2x only)
Port number (physical port number for single-ended ports, logi-
cal port number for balanced ports)
R&S ZNB/ZNBT-K220 | R&S ZNB/ZNBT-K230 | R&S ZNB/
ZNBT-K210
See "Coupon A / Coupon B section"
SYMMetric2x
☑
☑
☑
CALCulate:FMODel:DEASsistant:COUPon:<LEFT|RIGHt>:PORT
select the port(s) at which the test coupon is measured.
CALCulate:FMODel:DEASsistant:COUPon:<LEFT|RIGHt>:MEASure
SYMMetric2x | OPEN1x | SHORt1x | OPSHort1x
Test coupon type
SYMMetric2x
Symmetric 2 x Thru
OPEN1x SHORt1x
☑ ☑
☑ ☑
⃞ ⃞
CALCulate:FMODel:DEASsist
Command reference
SCPI command reference
(CALCulate:
on page 658
(CALCulate:
OPSHort1x
☑
⃞
⃞
to
889