R&S ZNB Series User Manual page 695

®
R&S ZNB/ZNBT
"Trace Cumulative Low Color" is the color that is used for the occurrence value 1,
"Trace Cumulative High Color" is the color that is used for the most frequent occurren-
ces. No occurrence (value 0) is always displayed fully transparent with the background
being visible.
OK / Cancel
"OK" enables/modifies the eye diagram, "Cancel" leaves the
out applying possible changes.
Remote command:
CALCulate<Chn>:EYE:STATe
5.16.2.6 Advanced Settings dialog
The "Advanced Settings" dialog gives full access to the calculation chain of the eye
diagram simulation.
Access: System – [Applic] > "TDR" > "Eye Diag" > "Advanced Settings..."
This dialog is available with
K20 only.
Controls in the dialog
●
Generator, Emphasis,
nal of the DUT
●
DUT
the DUT and to configure its DC properties.
●
Equalization
A green LED indicates that the respective building block is active. However the calcula-
tion chain can also be shortened using the
[Slider]
Allows you to shorten the simulation/calculation chain without deactivating the building
blocks at the tail end.
Remote command:
CALCulate<Chn>:EYE:VIEW
Define Colors...
See
User Manual 1173.9163.02 ─ 62
Jitter
allows you to switch between different transmission (and reflection) paths of
allows you to perform signal equalization at the "virtual receiver".
"Define Colors" on page 694
Extended time domain analysis
and Noise allow you to specify the simulated input sig-
[Slider]
GUI reference
Applic softtool
Eye Diagram dialog
option R&S ZNB/ZNBT-
control below the building blocks.
with-
695