R&S ZNB Series User Manual page 671

®
R&S ZNB/ZNBT
If the recall set to be loaded contains a switch matrix configuration and no differences
to the current switch matrix configuration are detected, the recall set is loaded without
further inquiry. Otherwise you are asked if you want to adapt the configuration:
Select "Cancel" to abort the recall process or "OK" to open the
Configuration dialog
Note: In case the recall set could only be loaded after adjusting some incompatible
settings, the info message "The setup data changed while loading" is displayed.
Incompatibilities can arise, for example, if you attempt to load a recall set of a different
R&S ZNB/ZNBT model or with different optioning. Not all incompatibilities can be
adjusted.
Remote command:
MMEMory:LOAD:STATe
Save
Saves the active recall set to a file (*.znx|*.znxml).
Displays the
recall set file.
Remote command:
MMEMory:STORe:STATe
Recent Files
The buttons are labeled with the last recall sets which were stored in the current or in
previous sessions. They open the corresponding recall set.
5.14.1.2 Restore Switch Matrix Configuration dialog
When opening an existing recall set file, it can be necessary to adapt the current sys-
tem configuration to the switch matrix configuration of the recall set. The "Restore
Switch Matrix Configuration" dialog guides you through this process.
User Manual 1173.9163.02 ─ 62
that guides you through the required configuration changes.
Save Dialog that allows you to specify a file name and location for the
GUI reference
File softtool
Restore Switch Matrix
671