R&S ZNB Series User Manual page 678

®
R&S ZNB/ZNBT
Make sure to deactivate "Simulation Noise" before exporting traces to file. Otherwise
your exported results comprise an "artificial" random component.
Exit
Persists the current state of all opened setups and ends the analyzer session. These
states are automatically recalled when the analyzer application is restarted.
Tip: This button is equivalent to the Windows
close icon
5.14.7 Configure Additional Simulation Data dialog
The "Configure Additional Simulation Data" allows you to define port-specific S-param-
eter data for the current channel (see
on page 279).
Access: System – [File] > "More" > "Config Additional Simulation Data..."
5.14.7.1 Configure Additional Imports tab
On the "Configure Additional Imports" tab, you can load additional Touchstone files and
overwrite the current channel's S-parameter data by selected S-parameter traces from
these files. These data take precedence over global, setup-specific, and channel-spe-
cific data (see
User Manual 1173.9163.02 ─ 62
in the title bar of the main firmware application window.
"Load Simulation Data..."
®
"Close window" command and to the
Chapter 4.7.31.1, "Simulation
on page 677).
GUI reference
File softtool
data",
678