R&S ZNB Series User Manual page 882

®
R&S ZNB/ZNBT
Parameters:
<EyeView>
Options:
Manual operation:
7.3.1.5 CALCulate:FILTer[:GATE]...
The CALCulate:FILTer[:GATE]... commands define the properties of the time
gate which is used to optimize the time domain response.
CALCulate:FILTer[:GATE]:TIME:AOFFset
CALCulate<Chn>:FILTer[:GATE]:TIME:CENTer
CALCulate<Chn>:FILTer[:GATE]:TIME:DCHebyshev
CALCulate<Chn>:FILTer[:GATE]:TIME:SHAPe
CALCulate<Chn>:FILTer[:GATE]:TIME:SHOW
CALCulate<Chn>:FILTer[:GATE]:TIME:SPAN
CALCulate<Chn>:FILTer[:GATE]:TIME:STARt
CALCulate<Chn>:FILTer[:GATE]:TIME:STOP
CALCulate<Chn>:FILTer[:GATE]:TIME:STATe
CALCulate<Chn>:FILTer[:GATE]:TIME[:TYPE]
CALCulate<Chn>:FILTer[:GATE]:TIME:WINDow
CALCulate:FILTer[:GATE]:TIME:AOFFset <Boolean>
Activates the operating mode where the time gate is moved in the opposite direction
when the "Delay" setting is changed.
Parameters:
<Boolean>
User Manual 1173.9163.02 ─ 62
STIMulus | EMPHasis | JITTer | NOISe | DUT | EQUalization
The rightmost building block that shall be part of the calculation
chain STIMulus > EMPHasis > JITTer > NOISe > DUT > EQUali-
zation.
Note that the selected block must be active, for example
CALCulate1:EYE:VIEW JITTER requires
CALCulate<Chn>:EYE:JITTer:STATe
Conversely, if CALCulate1:EYE:VIEW is set to JITTER and
subsequently CALCulate1:EYE:JITTer:STATe is turned
OFF, the calculation chain is further shortened to the next active
building block.
R&S ZNB/ZNBT-K20
See "[Slider]" on page 695
......................................................................... 882
.................................................................883
..................................................................884
.................................................................. 884
....................................................................885
................................................................... 885
................................................................... 885
................................................................... 886
.................................................................. 886
............................................................... 886
ON | OFF - enable or disable "Adjust Time Gate".
*RST: OFF
Command reference
SCPI command reference
to be ON.
......................................................... 883
882