R&S ZNB Series User Manual page 856

®
R&S ZNB/ZNBT
Query parameters:
<Data>
Usage:
Options:
Manual operation:
Stimulus axis:
time
Stimulus axis:
distance
CALCulate<Chn>:DTIMe:LIMit:FAIL? <Boolean>
Indicates whether the skew has passed or failed.
Suffix:
<Chn>
Return values:
<Boolean>
Usage:
Options:
CALCulate<Chn>:DTIMe:LIMit:FAIL:BEEP <Boolean>
Deprecated command: Since version 3.45, generating sounds is no longer supported
by the analyzer firmware.
Defines whether the R&S ZNB/ZNBT makes an audible beep on skew limit violations.
Suffix:
<Chn>
Parameters:
<Boolean>
User Manual 1173.9163.02 ─ 62
ALL
If omitted, a single numeric value is returned. If ALL is specified,
the result consists of 6 numeric values. Furthermore, the inter-
pretation of the result values depends on the active trace's stim-
ulus axis (CALCulate<Chn>:TRANsform:TIME:XAXis). See
the table below.
Note that the skew value is positive, if, at the defined position
(CALCulate<Chn>:DTIMe:POSition), the active trace is to
the right of the reference trace.
Query only
R&S ZNB/ZNBT-K20
See "Extended Info"
<Data> omitted <Data> = ALL
<skew time> <skew time>,<skew distance>, <X value of ref. point on current
trace>, <Y value of ref. point on current trace>, <X value of ref.
point on reference trace>, <Y value of ref. point on reference
trace>
<skew distance> <skew distance>, <skew time>, <X value of ref. point on cur-
rent trace>, <Y value of ref. point on current trace>, <X value of
ref. point on reference trace>, <Y value of ref. point on refer-
ence trace>
.
Channel number used to identify the active trace
0 – skew check has passed
1 – skew check has failed
Query only
R&S ZNB/ZNBT-K20
.
Channel number used to identify the active trace
*RST: OFF
Command reference
SCPI command reference
on page 710
856