®
R&S
ZNB/ZNBT
Sweep Sequencer tab
Gives access to the "Sweep Sequencer" functionality, see
Sequencer",
GPIOs tab
The "GPIOs" tab is split into two parts:
●
The left part of the table area (up to column "Output Voltage") allows you to define
and apply the GPIO pin voltages (see
●
The right part allows you to define and execute voltage and current measurements
on the GPIO pins (see
The "Apply" button activates both the "Output Voltage" and "Range" ("Shunt" resist-
ance) settings. The "Meas" button starts the voltage and current measurements.
User Manual 1173.9163.02 ─ 62
on page 558.
"GPIO voltage and current measurements"
Channel Config softtool
Chapter 5.12.1.6, "Sweep
"Basic GPIO configuration"
GUI reference
on page 556).
on page 557)
552