R&S ZNB Series User Manual page 982

®
R&S ZNB/ZNBT
CALCulate<Chn>:RIPPle:SEGMent<Seg>:LIMit <Limit>
Defines the ripple limit for ripple limit range no. <Seg>. A range must be created first to
enable this command (e.g. CALCulate<Chn>:RIPPle:DATA). See
"Rules for ripple test
Tip: To define several ripple limit ranges with a single command, use
CALCulate<Chn>:RIPPle:DATA.
Suffix:
<Chn>
<Seg>
Parameters:
<Limit>
Example:
Manual operation:
CALCulate<Chn>:RIPPle:SEGMent<Seg>:RESult?
Returns the result of the ripple limit check in the previously defined limit range no.
<Seg>. The response consists of two parameters:
● <Boolean> – 0 for "passed", 1 for "failed".
●
<Limit> – measured ripple in the limit range. A result is returned even if the limit
check in the range no. <Seg> is disabled; see example below.
A reset deletes all ripple limit ranges. Use CALCulate<Ch>:RIPPle:FAIL? to query
the result for global ripple limit check.
Note: In remote control, the ripple limit check result is calculated once at the end of
each sweep. If the ripple limits are changed, a new sweep is required to obtain upda-
ted ripple limit check results. In single sweep mode (INITiate<Ch>:CONTinuous
OFF), the new sweep must be started explicitly. This behavior is different from manual
control where a changed ripple limit line can directly affect the pass/fail result of the
displayed trace.
Suffix:
<Chn>
<Seg>
User Manual 1173.9163.02 ─ 62
definition", on page 147.
.
Channel number used to identify the active trace
Number of the ripple limit range.
Ripple limit in the range. The unit is adjusted to the format of the
active trace (CALCulate<Chn>:FORMat).
Range: Virtually no restriction for ripple limit ranges.
*RST: n/a (no ripple limit line defined after a reset)
Default unit: See above.
See
CALCulate<Chn>:RIPPle:SEGMent<Seg>:STIMulus:
STARt
See "Range List" on page 384
.
Channel number used to identify the active trace
Number of the ripple limit range.
Command reference
SCPI command reference
Chapter 4.4.1.2,
982