Table of Contents
Advertisement
®
R&S
ZNB/ZNBT
Options:
Manual operation:
CALCulate<Chn>:EYE:MASK:SHAPe:POLYgon:VERTical <Main>[, <Minor>]
Defines the main [and minor] height of the center polygon in the mask of the related
eye diagram. The
CALCulate<Chn>:EYE:MASK:SHAPe:POLYgon:TYPE
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Use
vate the center polygon in the eye mask. The eye mask test is enabled/disabled using
CALCulate<Chn>:EYE:MASK:STATe.
Suffix:
<Chn>
Parameters:
<Main>
<Minor>
Options:
Manual operation:
CALCulate<Chn>:EYE:MASK:SHOW <Boolean>
Defines the visibility of the configured eye mask in the related eye diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Suffix:
<Chn>
Parameters:
<Boolean>
Options:
Manual operation:
CALCulate<Chn>:EYE:MASK:STATe <Boolean>
Defines whether the eye mask test shall be run after every recalculation of the related
eye diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Suffix:
<Chn>
User Manual 1173.9163.02 ─ 62
R&S ZNB/ZNBT-K20
See
geometric interpretation
CALCulate<Chn>:EYE:MASK:SHAPe:POLYgon:STATe
.
Channel number used to identify the active trace
Default unit: V
Default unit: V
R&S ZNB/ZNBT-K20
See
.
Channel number used to identify the active trace
*RST:
R&S ZNB/ZNBT-K20
See
.
Channel number used to identify the active trace
"Polygon Setup"
on page 705
depends on the selected polygon type (see
"Polygon Setup"
on page 705
OFF
"Show Mask"
on page 703
Command reference
SCPI command reference
on page 875):
to activate or deacti-
876
Advertisement
Chapters
Table of Contents
