®
R&S
ZNB/ZNBT
Use
●
"Active Channel" if you only want to calibrate the active channel
●
"All Channels" if you want to calibrate all channels in the current recall set
●
"Selected Channels" if you want to calibrate only certain channels
5.11.1.3
Calibration Unit wizard
The "Calibration Unit" wizard guides you through the setup and execution of an auto-
matic calibration.
Access: Channel – [Cal] > "Start Cal" > Calibration – "Start... (Cal Unit)"
The wizard proceeds in three steps.
1.
Step 1: Ports
(along with its characterization).
2.
Step 2: Connections
R&S ZNB/ZNBT and the calibration unit.
3.
Step 3: Cal Unit
provided by the calibration unit. Finally, you can either apply the resulting error
terms to the related channels, or discard them.
Background information
Refer to
User Manual 1173.9163.02 ─ 62
allows you to configure the calibration and to select a calibration unit
allows you to define the port assignments between the
guides you through the required measurements on the standards
Chapter 4.5.5, "Automatic
calibration",
on page 181.
GUI reference
Cal softtool
448