Calculate<Ch>:Data:mdata:interpolate; Calculate<Chn>:Data:nsweep:count; Calculate<Chn>:Data:nsweep:first; Calculate<Chn>:Data:nsweep[:Last] - R&S ZNB Series User Manual

®
R&S ZNB/ZNBT
CALCulate:DATA:DALL? <Format>
Reads the current response values of all data traces of the current recall set. Use
CALCulate:DATA:ALL?
Query parameters:
<Format>
Return values:
<Data>
Example:
Usage:
CALCulate<Ch>:DATA:MDATa:INTerpolate
Uses linear inter-/extrapolation to "regrid" all memory traces of the related channel to
the channel's current stimulus values.
Suffix:
<Ch>
Usage:
CALCulate<Chn>:DATA:NSWeep:COUNt?
Reads the number of completed sweeps in single sweep mode
CONTinuous
sweep cycle.
Tip:
This command can only be used for
Suffix:
<Chn>
Example:
Usage:
CALCulate<Chn>:DATA:NSWeep:FIRSt? <Format>, <FwCount>[, <FwCountEnd>]
Reads the response values of a trace or a consecutive group of traces acquired in sin-
gle sweep mode
Tip:
This command can only be used for
User Manual 1173.9163.02 ─ 62
to query data traces and memory traces.
FDATa | SDATa | MDATa
Output format for the S-parameter data, see
CALCulate<Chn>:DATA.
Response values either in ASCII or block data format, depend-
ing on the current
Analogous to CALCulate:DATA:DALL?; see
CALCulate<Chn>:DATA.
Query only
.
Channel number
Event
OFF). The trace can be any of the traces acquired during the single
[SENSe<Ch>:]SWEep:COUNt
.
Channel number used to identify the active trace
See
CALCulate<Chn>:DATA:NSWeep:FIRSt?
Query only
(INITiate<Ch>:CONTinuous
[SENSe<Ch>:]SWEep:COUNt
SCPI command reference
setting.
FORMat[:DATA]
OFF).
Command reference
(INITiate<Ch>:
> 1.
> 1.
852