R&S ZNB Series User Manual page 902

®
R&S ZNB/ZNBT
Parameters:
<Frequency>
Options:
Manual operation:
CALCulate:FMODel:DELT:TCONfig <Boolean>
Defines how the analyzer firmware sets up the diagram area for the Delta-L measure-
ment.
Parameters:
<Boolean>
Options:
Manual operation:
CALCulate:FMODel:DELT:TDR <Boolean>
If the
allows you to add the TDR-based converted impedance traces to the recommended
trace configuration.
Parameters:
<Boolean>
Options:
Manual operation:
CALCulate:FMODel:EZD...
Commands for Eazy Deembedding (see
IEEE
User Manual 1173.9163.02 ─ 62
Frequency values
The default MINimum frequency is the standard Delta-L start fre-
quency of 10 MHz. The default MAXimum frequency is either 20
GHz or the instrument's maximum frequency, whichever is
smaller.
Default unit: Hz
R&S ZNB/ZNBT-K231
See "Sweep Frequency"
ON (1)
Use the recommended trace configuration, i.e. display each of
the traces in a separate diagram.
OFF (0)
Display all traces in a single diagram.
R&S ZNB/ZNBT-K231
See "Trace"
Time domain analysis
OFF (0)
TDR-based impedance traces added
ON (1)
TDR-based impedance traces not added
*RST:
R&S ZNB/ZNBT-K231
See "Trace"
370", on page 250).
on page 664
on page 664
option R&S ZNB/ZNBT-K2 is installed, this command
OFF
on page 664
Chapter 4.7.8, "Eazy de-embedding based on
Command reference
SCPI command reference
902