Table of Contents
Advertisement
®
R&S
ZNB/ZNBT
CALCulate<Chn>:MARKer<Mk>:MODE <Mode>
CALCulate<Chn>:MARKer<Mk>:REFerence:MODE <Mode>
Defines the positioning mode of the related marker (see
on page 940). The marker doesn't have to be created before, the mode can be
assigned in advance.
Suffix:
<Chn>
<Mk>
Parameters:
<Mode>
Example:
Example:
Manual operation:
CALCulate<Chn>:MARKer:MPEak:EXCursion <TargetSearchVal>
Defines a minimum excursion value for multiple peak searches.
Use
Suffix:
<Chn>
Parameters:
<Value>
Manual operation:
User Manual 1173.9163.02 ─ 62
.
Channel number used to identify the active trace
Marker number (ignored for reference markers)
CONTinuous | DISCrete
CONTinuous - marker can be positioned on any point of the
trace, and its response values are obtained by interpolation.
DISCrete - marker can be set to discrete sweep points only.
*RST:
Suppose that the active recall set contains an active trace no. 1.
CALC:MARK:MODE DISC; :CALC:MARK2:MODE CONT
Create marker 1 in discrete mode and marker 2 in continuous
mode.
CALC:MARK ON; MARK2 ON
Display the two markers. Due to the different modes the horizon-
tal positions can be different.
Suppose that the active recall set contains an active trace no. 1.
CALC:MARK:REF:MODE DISC
CALC:MARK2:REF:MODE CONT
Create the reference marker in discrete mode and marker 2 in
continuous mode.
CALC:MARK:REF ON; :CALC:MARK2 ON
Display the two markers. Due to the different modes the horizon-
tal positions can be different.
See
CALCulate<Chn>:MARKer:MPEak:EXCursion:STATe
.
Channel number used to identify the active trace
Minimum peak excursion
The unit is derived from the active trace format and cannot be
modified. Changing the trace format resets the excursion to a
format-specific default value.
See
CONT
"Discrete"
on page 395
"Excursion Settings"
on page 404
Command reference
SCPI command reference
"Marker addressing"
to activate it.
953
Advertisement
Chapters
Table of Contents
