R&S ZNB Series User Manual page 890

®
R&S ZNB/ZNBT
Options:
Manual operation:
CALCulate:FMODel:DEASsistant:DUT:MEASure
Measures DUT + fixture at the ports defined using
DEASsistant:DUT:PORT.
Usage:
Options:
Manual operation:
CALCulate:FMODel:DEASsistant:DUT:PORT <Position>, <PortNum>
Before you can measure DUT + fixture or run the fixture deembedding tool
(CALCulate:FMODel:DEASsistant:RUN), you have to define consecutive port
ranges for the left/right side of the fixture.
Parameters:
<Position>
Options:
Manual operation:
CALCulate:FMODel:DEASsistant:DUT:TYPE <ScpiDutType>
Selects the DUT type for the "Deembedding Assistant".
User Manual 1173.9163.02 ─ 62
OPEN1x
1 x Open
SHORt1x
1 x Short
R&S ZNB/ZNBT-K220 | R&S ZNB/ZNBT-K230 | R&S ZNB/
ZNBT-K210
See "Coupon A / Coupon B section"
Event
R&S ZNB/ZNBT-K220 | R&S ZNB/ZNBT-K230 | R&S ZNB/
ZNBT-K210
See "Measure / Apply section"
UPLeft | UPRight | LOLeft | LORight
Defines the port ranges.
For DUTs with one single-ended or balanced ports on the left/
right, specifying an up-port is sufficient for this side.
UPLeft
Upper end of the port range on the left
UPRight
Upper end of the port range on the right
LOLeft
Lower end of the port range on the left
LORight
Lower end of the port range on the right
R&S ZNB/ZNBT-K220 | R&S ZNB/ZNBT-K230 | R&S ZNB/
ZNBT-K210
See "Measure / Apply section"
Command reference
SCPI command reference
on page 658
CALCulate:FMODel:
on page 660
on page 660
890