R&S ZNB Series User Manual page 784

®
R&S ZNB/ZNBT
●
Table 5-8: Interface types for external power meters and address formats
Physical Interface
interface (protocol)
(connector)
LAN VXI-11
SOCKET
GPIB GPIB0 ...
GPIB9
LAN or USB Other
Remote command:
SYSTem:COMMunicate:RDEVice:PMETer<Pmtr>:DEFine
Auto Config
Causes the analyzer to clear the lists of "Known Devices" and "Configured Devices"
and to configure all R&S NRPxxS/SN power sensors, detected at any of the USB
ports, automatically. No manual configuration is required.
Remote command:
SYSTem:COMMunicate:RDEVice:PMETer:CONFigure:AUTO[:STATe]
5.18.4.3 External Power Meter Config dialog
Allows to modify configuration of certain external power meters, i.e. settings that are
persistently stored on the power meter (and NOT on the R&S ZNB/ZNBT). This
requires the respective device to be online, i.e. connected, switched on and ready to
be used.
Access: System – [Setup] > "External Devices" > "Power Meter Config..."
User Manual 1173.9163.02 ─ 62
If an instrument is connected to the R&S ZNB/ZNBT, the entries in the [Driver for
New Instrument] panel can be auto-detected for the specified interface type and
address.
"Identify" sends an identification query ("IDN?") to the specified device address to
identify the type and serial number of the connected power meter and select an
appropriate driver file. Power meter driver files (*.pwm) are stored in the
Resources\ExtDev subdirectory of the analyzer's program directory.
Address
<IpAddress>
for example 10.11.12.13
<IpAddress>::<PortNo>
for example 10.11.12.13::50000
<Address>
for example 20
Interface-specific, e.g. for SOCKET:
TCPIP0::<IpAddress>::<PortNo>::SOCKET
GUI reference
Setup softtool
Remarks
Full VISA resource string:
TCPIP[board]::<Address>[::INSTR]
LAN connection with pure TCP/IP protocol;
refer to your VISA user documentation.
Full VISA resource string:
GPIB[board]::<Address>[::INSTR]
Use complete VISA resource string.
784