R&S ZNB Series User Manual page 584

®
R&S ZNB/ZNBT
●
Max. IM Order: 9.
From left to right, the peaks correspond to the following intermodulation products:
–
–
–
–
–
–
–
–
–
–
●
"Add CW Mode"
Activates a new channel for the spectrum measurement. The "CW Frequency" plus
half the "Tone Distance" defines the center of the diagram.
●
"Max IM Order"
Defines the width of the spectrum measurement.
Remote command:
[SENSe<Ch>:]FREQuency[:CW]
[SENSe<Ch>:]FREQuency:IMODulation:SPECtrum:MORDer
[SENSe<Ch>:]FREQuency:IMODulation:SPECtrum[:STATe]
5.12.4.2 Intermodulation Presetting wizard
The "Intermodulation Presetting" wizard guides the user through the setup of an inter-
modulation measurement.
User Manual 1173.9163.02 ─ 62
lower IM9
lower IM7
lower IM5 (marker M6)
lower IM3 (marker M5)
lower tone (marker M1)
upper tone (marker M2)
upper IM3 (marker M3)
upper IM5 (marker M4)
upper IM7
upper IM9
GUI reference
Channel Config softtool
584