R&S ZNB Series User Manual page 656

®
R&S ZNB/ZNBT
Remote command:
CALCulate:FMODel:DEASsistant:DUT:TYPE
CALCulate:FMODel:DEASsistant:PRESet
Left: Model A / Right: Model A|B
Allows you to select a coupon type, i.e. to define how the coupling at the left side (lead-
in) and right side (lead-out) of the DUT is modeled.
If you select the same model for the left and right side and check
Left and Right"
the measurement phase only the data of a single coupon ("Coupon A") must be mea-
sured or loaded from file.
"Single Ended" This coupon model is appropriate for one or more single-ended inputs
"Balanced"
User Manual 1173.9163.02 ─ 62
on page 657, then also the right side is labeled with "Model A" and in
(outputs), where:
●
All inputs (outputs) use the same coupon model and
●
There is no interaction between inputs (outputs) if more than one
is present on the DUT
Figure 5-66: n single-ended input ports (uncoupled)
This coupon type is appropriate for one or more balanced inputs (out-
puts), if:
●
All inputs (outputs) use the same coupon model and
●
There is no interaction between inputs (outputs) if more than one
is present on the DUT
Figure 5-67: n balanced input ports
GUI reference
Offset Embed softtool
"Use Same Coupon
656