®
R&S
ZNB/ZNBT
The available GUI elements for the limit line definition are the same as in the general-
purpose limit line setup dialog. For their description, see
Lines
Prompt before every port check
This option comes in handy if you want to connect a particular device such as a reflec-
tion standard to the related port before you
Execute/Repeat
Executes or repeats the "Active" port power tests with their current
level
PASS/FAIL results and in the diagram area:
The PASS/FAIL results are also written to the
Remote command:
SYSTem:OPCHeck:PLEVel:PORT<Port>?
Summary page
Summarizes the check results and allows you to
User Manual 1173.9163.02 ─ 62
dialog",
on page 377.
settings. The firmware displays the relevant a- and b-wave traces, limit lines and
Chapter 5.6.1.2, "Define Limit
execute or repeat
the test.
Log
area.
print
them.
GUI reference
Setup softtool
limit line and power
774